BACnet in Workbench64 and GraphWorX64

In most cases, you would browse directly for the BACnet devices via Data Browser and add BACnet data in your GraphWorX64 display as process points (NOTE: See Fast Browsing BACnet Devices).

Follow the steps below:

Start GraphWorX64 from Workbench by clicking on Start -> Programs -> ICONICS GENESIS64 -> Workbench64
Once Workbench launches create a new display by clicking on the GraphWorX64 button in the Home tab of the ribbon.
Add a new process point on your GraphWorX64 display and browse for the BACnet data tags under BACnet folder.
When the Data Browser appears, make sure that you’re in the Data Browser’s home screen (e.g. by clicking on the ‘Home’ item in the left-side ‘Shortcuts’ pane). In that section, choose the 'BACnet' list item. You should see list of discovered devices (if you don’t see any, or you don’t see the one you want, click on the ‘Refresh’ button in the upper-right corner to get an actual list of discovered devices. You can out find more about this behavior HERE.

Figure 6 - Browsing BACnet Data via Data Browser

When you have PPT added on your GraphWorX64 display, switch to Runtime mode and you would see the BACnet value resolved.